Knitting Browser tool
Measure your knitting or crochet swatch gauge, calculate stitch counts for hats or blankets, and compare your gauge to pattern instructions with ease.
How to measure your swatch
Always knit or crochet a swatch in the exact yarn and stitch pattern you plan to use. Wash, block, and dry your swatch just like you will care for the finished project. Lay it flat without stretching.
Count your stitches horizontally across the middle of the swatch, and your rows vertically through the centre. Enter the exact distance over which you counted. Avoid measuring near the edge stitches or cast-on edge, because edge stitches curl and distort your true tension.
Craft Yarn Council standards treat 4 inches and 10 centimetres as approximate equivalents on yarn ball bands. But 4 inches is exactly 10.16 centimetres. Over a wide project like a baby blanket or sweater, that fraction of an inch can change the fit, so this calculator reports gauge over both measurements.
Calculating your cast-on stitch count
To work out how many stitches to cast on for a worsted beanie or scarf, multiply your target width by your stitches per inch or centimetre.
If your stitch pattern needs a specific repeat, enter the stitch multiple and offset. For a pattern written as “multiple of 4 plus 2”, enter 4 for the multiple and 2 for the offset. The calculator finds the closest matching positive count that fits, rounding towards the larger count on an exact tie. For crochet, follow your pattern’s instructions for any turning chain.
Comparing your gauge to a pattern
If your swatch doesn’t match the pattern gauge, don’t panic. The comparison tool divides the pattern’s stitch count by its stitch density to find the designer’s intended width. It then applies your own stitch density to that width. The difference tells you how the original stitch count would work up at your gauge. Remember that row gauge and armhole or neckline shaping may also need adjustments.