Quilt backing calculator and yardage planner

Backing plan. Fabric to buy

Quilt top and fabric. Your measurements

See both seam optionsseam options

Calculated on your device.

Quilting Browser tool

Calculate quilt backing yardage for horizontal and vertical seams. Compare fabric layouts, cut lengths, and wide-back yardage in inches or cm.

How to measure your quilt top and backing overhang

Lay your finished quilt top flat and measure its width and length across the centre, not just along the borders. Backing needs to be larger than the quilt top so a quilter can clamp and square it on a frame or baste it smoothly on the floor.

The calculator adds your chosen overhang twice—once for each side. For example, if you have a 60 × 72 inch throw quilt and allow 4 inches (about 10 cm) on every side, your final backing must measure 68 × 80 inches.

How the seam and panel math works

When your backing dimensions exceed the usable fabric width, you must seam panels together:

  • Vertical seams run along the quilt length.
  • Horizontal seams run across the quilt width.

The calculator budgets a ½ inch seam allowance on both raw edges, meaning each join takes 1 inch of combined panel width. If the total backing size fits within the usable fabric width, you need only one single panel. Total yardage includes the overhang and rounds up to the nearest ⅛ yard or 10 cm so you aren’t left short at the cutting mat.

Good to know about fabric widths and grain

Usable fabric width means the clean yardage inside the woven selvages (selvedges). Always trim off selvages before joining panels because their dense weave shrinks differently and puckers seams.

Actual widths vary by manufacturer. While this calculator’s 108-inch wide-back preset assumes the full 108 inches is usable, Missouri Star budgets for 104 inches to stay safe. If you prewash your fabric, re-measure the usable width afterward to account for shrinkage. Lastly, if you are matching a directional print or pattern repeat across panels, buy a little extra yardage.

A few quick answers

How much extra backing fabric do I need for longarm quilting?

A 4-inch (about 10 cm) overhang on all four sides is standard for most longarm quilters. That adds 8 inches (20 cm) total to both width and length. Always confirm your quilter’s preferred margin.

Should my quilt backing seam be horizontal or vertical?

Longarm quilters often prefer horizontal seams because they roll onto the frame parallel to the rollers. For domestic machine quilting, either direction works well. Compare both layouts to see which uses less fabric.

What is usable fabric width?

Usable width is the actual fabric measurement between the unprinted, woven selvages (selvedges). Standard 42-inch fabric usually leaves about 40 inches of usable width once selvages are trimmed away.

When can I use a single backing panel without seams?

If your quilt’s total backing dimension—including the extra overhang—is narrower than your usable fabric width, you can use a single seamless length of regular or 108-inch wide-back fabric.