Quilt binding calculator and strip planner

Binding plan

Quilt and binding dimensions. Your measurements

Measure between the selvages. Diagonal strip joins are included.

See binding planbinding plan

Calculated on your device.

Quilting Browser tool

Calculate straight-grain quilt binding strips, total length, and yardage. Plan strip widths and diagonal seam joins for quilts of any size.

How to measure your quilt perimeter

To find your binding length, measure your quilted top across the middle and down the centre. Add those two numbers together and multiply by two to get the perimeter.

Next, add an extra margin—typically 10 to 12 inches—to give you room to navigate around corners and join the strip ends cleanly. If you plan to prewash your fabric, wash and press it first, then measure the usable width between the woven selvages (selvedges).

How the strip and yardage math works

Straight-grain binding is cut across the width of the fabric (crosswise grain), running selvage to selvage. Joining strip ends with 45-degree diagonal seams spreads bulk evenly around your quilt edges.

Each diagonal seam consumes fabric length equal to one strip width. The calculator determines the minimum number of strips needed to cover your full perimeter plus corners and seam joins:

  1. It divides the total required binding length by your usable fabric width minus the diagonal seam allowance.
  2. It rounds up to the next full strip.
  3. It multiplies that strip count by your cut width, rounding up the final purchase amount to the next ⅛ yard or 10 cm.

Good to know about fabric widths and curves

Usable fabric widths vary between textile mills. This calculator defaults to 40 inches of usable width, following the APQS guide. Other references, such as Quilter’s Paradise, default to 43 inches and refer to perimeter as binding length.

For ordinary quilts with straight edges, crosswise straight-grain strips are strong, economical, and easy to handle. However, if your quilt features curved edges or scalloped corners, you will need bias binding cut at a 45-degree angle to bend smoothly without puckering. Bias binding uses a different layout and requires more yardage.

A few quick answers

How wide should I cut my quilt binding strips?

A cut width of 2½ inches (about 6.4 cm) is the classic standard for double-fold (French fold) binding on a throw quilt. Some makers prefer 2¼ inches for a tighter finish, so check your pattern instructions.

How much extra binding length do I need for corners and joins?

Adding 10 to 12 inches to your perimeter gives you plenty of slack to miter all four corners neatly and join the starting and ending tails with a flat diagonal seam.

Does this binding calculator account for diagonal seam joins?

Yes. Diagonal joins reduce seam bulk, but each 45-degree seam uses up a section of length equal to one strip width. The calculation includes that fabric loss.

When should I use bias binding instead of straight-grain binding?

Use straight-grain binding cut across the fabric width for standard square or rectangular quilts. Reserve bias binding—cut at a 45-degree angle—for quilts with curved edges or scalloped borders where the fabric must stretch.